Looking for South Beach Symposium lightbox LED modules? Compare internal LED bars when modular graphic lightboxes move between island and linear booth layouts.
Can I reuse the LEDs when the booth layout changes?
Reuse depends on the actual lightbox dimensions, mounting positions and circuit design. Moving intact panels differs from rebuilding a lit face; test the final translucent print before deciding to replace its LEDs.
What should I check before moving lightbox panels?
Review cable routes, connector access and cable strain in both layouts. Check the load on each power supply after panels are regrouped; a new layout does not automatically preserve the original circuit arrangement.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What details are needed to choose replacement LED bars?
Send both layout drawings, lit dimensions, clear depth, mounting spans, print samples and LED, connector and power labels. Match the selected bars to the actual frame and calculate circuit loads.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Compare all LED Modules below. Send your modular lightbox and layout drawings to review suitable internal LED bars and wiring.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Looking for South Beach Symposium lightbox LED modules? Compare internal LED bars when modular graphic lightboxes move between island and linear booth layouts.
Can I reuse the LEDs when the booth layout changes?
Reuse depends on the actual lightbox dimensions, mounting positions and circuit design. Moving intact panels differs from rebuilding a lit face; test the final translucent print before deciding to replace its LEDs.
What should I check before moving lightbox panels?
Review cable routes, connector access and cable strain in both layouts. Check the load on each power supply after panels are regrouped; a new layout does not automatically preserve the original circuit arrangement.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What details are needed to choose replacement LED bars?
Send both layout drawings, lit dimensions, clear depth, mounting spans, print samples and LED, connector and power labels. Match the selected bars to the actual frame and calculate circuit loads.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Compare all LED Modules below. Send your modular lightbox and layout drawings to review suitable internal LED bars and wiring.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.