Looking for ADX lightbox LED modules for a curved dental-brand backwall? Compare internal sources for the printed lightbox panels within your display wall.
How should LEDs be planned behind curved graphics?
Check each actual panel and cavity with its print, face material and usable depth. Compare edge-lit and rear-backlight positions in the assembled wall; the overall curve does not show the mounting space inside each panel.
Can rigid LED bars be bent to match the wall?
Do not bend rigid bars. Confirm straight mounting clearances and source orientation with the builder; a curved overall wall does not mean a curved LED bar is required.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What panel details should I send?
Send panel sections, finished graphics, curve layout, mounting space and supply specifications. These LEDs illuminate printed branding, not dental treatment areas or diagnostic equipment.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your curved backwall and panel sections to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Looking for ADX lightbox LED modules for a curved dental-brand backwall? Compare internal sources for the printed lightbox panels within your display wall.
How should LEDs be planned behind curved graphics?
Check each actual panel and cavity with its print, face material and usable depth. Compare edge-lit and rear-backlight positions in the assembled wall; the overall curve does not show the mounting space inside each panel.
Can rigid LED bars be bent to match the wall?
Do not bend rigid bars. Confirm straight mounting clearances and source orientation with the builder; a curved overall wall does not mean a curved LED bar is required.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What panel details should I send?
Send panel sections, finished graphics, curve layout, mounting space and supply specifications. These LEDs illuminate printed branding, not dental treatment areas or diagnostic equipment.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your curved backwall and panel sections to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.