Adjustable Square Tube Light Clamp for Trade Show Booth Lights

Square Tube Light Clamps – Up to 31mm, 5/10/20 Packs

Black / 5-Pack
$39.00
$39.00 $46.80
Skip to product information
Adjustable Square Tube Light Clamp for Trade Show Booth Lights
  • Adjustable Square Tube Light Clamp for Trade Show Booth Lights
  • Square tube light clamp dimensional drawing showing 65.9mm length and 31mm profile capacity
  • Black square tube light clamp with flat jaw for compatible exhibition display profiles
  • Trade show display light bracket – display panel light clip for booth wall and crossbar frames
  • Square-profile exhibition light clamp installed on a compatible booth wall frame
  • Display light clamp mounted on a compatible square crossbar in an exhibition booth
Square Tube Light Clamps – Up to 31mm, 5/10/20 Packs

Square Tube Light Clamps – Up to 31mm, 5/10/20 Packs

$39.00
$39.00 $46.80
Color
Pack Size

Square Tube Light Clamp for Trade Show Displays

This adjustable square tube light clamp provides a flat contact surface for compatible square and rectangular exhibition profiles where a round-jaw clamp may not seat correctly. The relevant clamping dimension is recommended up to 31mm (1.2 inches); compare the product drawing with your actual frame before ordering.

  • Application: pop-up display frames, square crossbars and exhibition structures
  • Adjustment: screw-adjusted jaw position and clamping pressure
  • Material: aluminum alloy
  • Finish: black or silver
  • Pack sizes: 5, 10 or 20 clamps

Measure the Profile Before Ordering

This clamp is not a universal mounting part. Confirm all of the following against the dimensional image or a sample:

  • Profile width, depth and wall shape
  • The actual dimension captured by the flat jaw
  • The interface between the clamp and display light
  • Installation orientation and required working load
  • Clearance for the adjustment screw and nearby frame parts

For Square and Rectangular Booth Profiles

The flat jaw is intended for compatible square tube booth frames, rectangular crossbars and flat-edge display structures. It may also fit a compatible Octanorm profile, but profile geometry varies by series; verify the exact dimensions rather than relying on the brand name.

Installation

  1. Measure the frame with the display light removed and power disconnected.
  2. Seat the clamp's flat contact surfaces squarely on the profile.
  3. Tighten the adjustment screw evenly without damaging or deforming the frame.
  4. Attach only a light with a compatible mounting interface.
  5. Test the completed assembly for movement and load before use above a display or public area.

When to Choose Another Mount

For frames deeper than 31mm, compare the measured profile with a larger C-clamp. For SEG channels, a compatible dual M8 bracket or M8 sliding block may provide a better interface. Each option requires a separate fit and load check.

Compare trade show booth clamps or send frame photos, dimensions and the light model for compatibility guidance.

Frequently Asked Questions

Does “up to 31mm” refer to every side of the profile?
No. Use the dimensional drawing to identify the relevant clamping dimension and compare it with your frame geometry.

Is it compatible with every square tube or Octanorm frame?
No. Profile size, wall shape, clearance and the light interface must all match.

Can it be used above a public area?
Only after the installer verifies fit, fasteners, working load and any required secondary safety measures for the venue.

You may also like