SIAL Canada LED Modules for Double-Sided Fabric Lightbox Depth Checks

SIAL Canada serves food and beverage exhibitors across Canada's alternating Montreal and Toronto editions. This selection supports independent pavilion builders specifying double-sided printed-fabric lightboxes. Compare all 26 LED Modules products while keeping the usable lighting space distinct from the external partition or frame dimensions.

Measure the space between the two installed printed faces

Draw both fabric channels, the tensioned print positions and the intended internal mounting support in the same frame section. Measure the remaining space for the module, lens, cable and connector after these parts are included. Do not infer light-source clearance from the thickness of a neighbouring partition, the width of a timber border or a drawing of the finished graphic alone. If a support divides the cavity, record the usable space toward each face separately before choosing edge lighting or rear backlighting.

Evaluate both faces on the same assembled frame

Install the intended prints on both sides and test the proposed source arrangement without removing the opposite face to make the sample look brighter. Check whether the internal support or cabling produces a visible pattern on either graphic. Keep both print references and the accepted cavity section with the LED model and positions. Recheck both faces if the support or source arrangement changes. Evaluate a separate logo lightbox on its own section instead of copying the larger panel's layout into a different cavity.

Compare LED lightbox sources

Does a double-sided textile specification establish enough depth for any LED bar?

No. It identifies the display construction, but the actual usable cavity and module envelope still need verification. These products are internal lightbox components, not partition structures, complete pavilion packages or food-inspection lights. The selection does not imply compatibility with an organizer's supplied system.

Before ordering

Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.

Send the double-sided frame section, installed fabric positions, internal support and both printed-face samples to discuss component options and a trial layout.

BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.