If a booth light makes a graphic or product difficult to see, check both the visible light source and reflections from the display before adding output. Glass, acrylic, glossy print, polished metal and screens can reflect a lamp into a visitor’s viewing position. The same setup can look acceptable from one position and distracting from another.
Start with the final display and viewing positions
Install the intended graphics, products, cases, screens and furniture before final aiming. Mark the main aisle approaches and the positions where people read labels or inspect products, including seated positions where relevant. Check under representative hall lighting; an empty wall or one photograph is not enough.
Distinguish direct glare, where the bright source itself is visible, from reflected glare, where its reflection interferes with the display. CCOHS’s lighting guidance identifies both and recommends evaluating the task from the normal viewing position. A dark patch may instead result from a blocked beam or inadequate coverage, so identify the problem before selecting a correction.
Adjust one light and follow the result
- Identify the lamp contributing to the reflection by testing approved, independently controlled groups where available. Keep visitor routes lit; do not improvise switching or disconnect a powered linked run.
- Follow the fixture instructions for safe adjustment. Isolate power where required and let hot parts cool. Move the head only within its permitted range; relocation of the clamp requires a suitable support and any required access equipment.
- Make a small change in head direction or permitted mounting position. Check where the reflection moves from each marked viewing position. Tilting farther down is not a universal solution.
- Check the full target again: smallest labels, graphic corners, shelves, case contents and faces used for demonstrations. Reducing one reflection must not hide another important detail.
- Secure the head and mount as instructed, then repeat the check. Record the accepted position rather than relying on a remembered angle.
Test each surface separately
- Matte fabric: inspect coverage and shadows as well as visible sources. A matte finish does not eliminate every glare problem.
- Glossy graphics: try a different permitted position or direction and watch the reflected bright area across all viewing positions. One successful position does not prove the whole aisle is clear.
- Glass or acrylic cases: check the front and side glazing with the products installed. A reflection that leaves one item can obscure another.
- Screens: run the intended content. Avoid directing an unnecessary beam at the screen, and check nearby graphic lighting for reflections and contrast.
- Polished products: decide which details must remain visible. Some highlights show shape, while others conceal labels or surface detail; assess the actual product.
Change the layout only after a trial
Two lights from different positions may improve coverage, but they can also create two distracting reflections. Test the proposed arrangement before buying more fixtures. For a wide graphic, compare overlapping coverage with the final print and inspect the centre, ends and lower panels. Neither a fixed head angle nor a lamp count guarantees the result.
Dimming is an option only when the exact fixture, driver and control are confirmed compatible. Colour-temperature selection does not establish dimming. An approved diffuser, louvre or other accessory may help where the manufacturer supports it; do not cover the source with improvised material.
Arm reach, mounting height, beam distribution and available adjustment work together. A longer arm changes the source position but does not guarantee better coverage or fewer reflections. Check clamp opening, contact surface, frame capacity, clearance and cable route before ordering from LED display arm lights.
Record the check and repeat it on site
Use photographs from the main approaches to record visible problems and final positions. Automatic exposure, HDR and processing can change the image, so a phone photo is not a calibrated brightness measurement or proof that glare is absent. Inspect the actual display; if photography or video matters, also review recordings from the intended camera and viewpoints.
Record the model, mounting point, aiming position, control settings and accepted viewing positions. Recheck after moving products, changing graphics or hall lighting, or transporting the stand. Use the booth-light placement guide for broader planning and compare exhibition arm lights by their own output, reach and mounting instructions.