Looking for Grand Rendez-vous lightbox LED modules? Compare internal sources for your own sign box and check the power architecture before replacing existing lighting.
Can LED modules directly replace fluorescent sign lamps?
Do not assume a socket replacement. Compare module mounting, source direction and the required supply with the existing layout. A low-voltage module is different from a mains-input retrofit lamp.
Which supply details should I check?
Check the chosen module’s specified input, polarity, connector and total load. Match the supply output and plan wiring runs within the product limits; the existing supply is not automatically suitable.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What information is needed to compare modules?
Send frame section, usable depth, face material, wiring diagram and supply-label details. Confirm component changes with the builder; no fit in existing tube sockets or approval of a sign conversion is claimed.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your lightbox layout and supply details to compare suitable sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Looking for Grand Rendez-vous lightbox LED modules? Compare internal sources for your own sign box and check the power architecture before replacing existing lighting.
Can LED modules directly replace fluorescent sign lamps?
Do not assume a socket replacement. Compare module mounting, source direction and the required supply with the existing layout. A low-voltage module is different from a mains-input retrofit lamp.
Which supply details should I check?
Check the chosen module’s specified input, polarity, connector and total load. Match the supply output and plan wiring runs within the product limits; the existing supply is not automatically suitable.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What information is needed to compare modules?
Send frame section, usable depth, face material, wiring diagram and supply-label details. Confirm component changes with the builder; no fit in existing tube sockets or approval of a sign conversion is claimed.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your lightbox layout and supply details to compare suitable sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.