Searching for Australasian Gaming Expo lightbox LED modules? Compare internal LEDs for printed security-brand and service graphics beside a separate screen demonstration.
Which LEDs suit printed security-service lightbox graphics?
Compare edge-lit and rear-backlight layouts with the finished print and usable depth. Test logos and service labels at the intended viewing distance; these LEDs illuminate printed graphics, not security or gaming equipment.
How should screen mounts and cables be planned?
Mark screen mounting hardware and cable routes on the frame section. Check whether they obstruct source placement or maintenance access; do not assume the whole lightbox cavity is available.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What graphic and mounting details should I send?
Send the printed face, label sizes, frame section, usable depth, screen-mount clearances and supply details. Choose the screen system separately; product fit in a particular branded frame must be confirmed with its builder.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your printed service graphic and mounting plan to compare suitable lightbox sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Searching for Australasian Gaming Expo lightbox LED modules? Compare internal LEDs for printed security-brand and service graphics beside a separate screen demonstration.
Which LEDs suit printed security-service lightbox graphics?
Compare edge-lit and rear-backlight layouts with the finished print and usable depth. Test logos and service labels at the intended viewing distance; these LEDs illuminate printed graphics, not security or gaming equipment.
How should screen mounts and cables be planned?
Mark screen mounting hardware and cable routes on the frame section. Check whether they obstruct source placement or maintenance access; do not assume the whole lightbox cavity is available.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What graphic and mounting details should I send?
Send the printed face, label sizes, frame section, usable depth, screen-mount clearances and supply details. Choose the screen system separately; product fit in a particular branded frame must be confirmed with its builder.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your printed service graphic and mounting plan to compare suitable lightbox sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.