Searching for VivaTech overhead lightbox LED modules or LED bars for exhibition canopy lightboxes? Compare internal sources for illuminated stand canopies in their planned mounting position.
Which LEDs suit an overhead canopy lightbox?
Compare edge-lit and rear-backlight layouts with face material, graphics and usable cavity. Test lens orientation and illumination in the intended overhead position, rather than approving only an upright sample.
Can an upright lightbox layout be reused overhead?
Check it again. Frame sections, internal supports and connector locations can change the usable optical space and service access. Secure each source using the selected model’s mounting method; LEDs do not support the canopy structure.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What canopy section and access details should I send?
Send face dimensions and material, canopy sections, source orientation, mounting space, service-access plan and supply specifications. The exhibit builder must separately confirm structural support and venue installation requirements.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send your canopy and access details to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Searching for VivaTech overhead lightbox LED modules or LED bars for exhibition canopy lightboxes? Compare internal sources for illuminated stand canopies in their planned mounting position.
Which LEDs suit an overhead canopy lightbox?
Compare edge-lit and rear-backlight layouts with face material, graphics and usable cavity. Test lens orientation and illumination in the intended overhead position, rather than approving only an upright sample.
Can an upright lightbox layout be reused overhead?
Check it again. Frame sections, internal supports and connector locations can change the usable optical space and service access. Secure each source using the selected model’s mounting method; LEDs do not support the canopy structure.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What canopy section and access details should I send?
Send face dimensions and material, canopy sections, source orientation, mounting space, service-access plan and supply specifications. The exhibit builder must separately confirm structural support and venue installation requirements.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send your canopy and access details to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.