Looking for LED modules for single or double-sided fabric lightboxes around OCTANORM Training Days? The partner describes hands-on comparisons across the system portfolio, which includes illuminated fabric frames. Compare independent internal LEDs here for your own lightbox prototype.
Can the same LED layout illuminate both sides of a lightbox?
Do not assume it can. Test each face with its intended graphic. Check LED placement, beam angle, internal supports and the available space before approving a double-sided construction.
What should I compare before ordering LEDs for a double-sided display?
Inspect both faces separately for bright spots, dark areas and unwanted image show-through. Record the frame depth, graphic material and light-source arrangement so the accepted prototype can be repeated.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
Are these modules approved replacements for OCTANORM lighting?
No approval is claimed. Verify the selected product’s dimensions, mounting, connector and electrical requirements against your construction before ordering.
Before ordering
Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send dimensions, face count, graphic references, internal support positions and supply details through Contact us to discuss candidates.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Looking for LED modules for single or double-sided fabric lightboxes around OCTANORM Training Days? The partner describes hands-on comparisons across the system portfolio, which includes illuminated fabric frames. Compare independent internal LEDs here for your own lightbox prototype.
Can the same LED layout illuminate both sides of a lightbox?
Do not assume it can. Test each face with its intended graphic. Check LED placement, beam angle, internal supports and the available space before approving a double-sided construction.
What should I compare before ordering LEDs for a double-sided display?
Inspect both faces separately for bright spots, dark areas and unwanted image show-through. Record the frame depth, graphic material and light-source arrangement so the accepted prototype can be repeated.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
Are these modules approved replacements for OCTANORM lighting?
No approval is claimed. Verify the selected product’s dimensions, mounting, connector and electrical requirements against your construction before ordering.
Before ordering
Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send dimensions, face count, graphic references, internal support positions and supply details through Contact us to discuss candidates.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.