Searching for ISSA Cleaning & Hygiene Expo Australia lightbox LED modules or LED bars for archway-enclosed exhibition lightboxes? Compare internal sources for cleaning-industry stand graphics.
Which LEDs suit a lightbox inside an archway?
Compare the real face, usable cavity and mounting spans with source dimensions and optics. The surrounding arch does not specify the LED layout or make rigid bars bendable.
Does the enclosure leave enough installation and service space?
Check mounting clearances and the route for replacing sources through the intended access panel. Test the assembled lightbox under planned operating conditions, including heat inside its enclosure; a bare-bar test does not establish the finished assembly's performance.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What enclosure and power details should I send?
Send face sample, frame depth, enclosure sections, straight mounting spans, access-panel and replacement route, source layout, connectors and supply. Verify existing-lightbox compatibility; these LEDs are display sources, not cleaning-machine components.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send your enclosed lightbox details to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Searching for ISSA Cleaning & Hygiene Expo Australia lightbox LED modules or LED bars for archway-enclosed exhibition lightboxes? Compare internal sources for cleaning-industry stand graphics.
Which LEDs suit a lightbox inside an archway?
Compare the real face, usable cavity and mounting spans with source dimensions and optics. The surrounding arch does not specify the LED layout or make rigid bars bendable.
Does the enclosure leave enough installation and service space?
Check mounting clearances and the route for replacing sources through the intended access panel. Test the assembled lightbox under planned operating conditions, including heat inside its enclosure; a bare-bar test does not establish the finished assembly's performance.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What enclosure and power details should I send?
Send face sample, frame depth, enclosure sections, straight mounting spans, access-panel and replacement route, source layout, connectors and supply. Verify existing-lightbox compatibility; these LEDs are display sources, not cleaning-machine components.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send your enclosed lightbox details to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.