Searching for BC Sign & Graphics Expo lightbox LEDs? Compare internal modules for your own indoor acrylic-face sign with the actual diffuser and printed or vinyl graphic.
Which LEDs suit an acrylic-face lightbox?
Test the actual acrylic grade, thickness and graphic with the proposed source layout. Face diffusion and transmission affect visible bright points and dark areas; a material name alone does not determine LED spacing.
Can I keep the same spacing after changing the face?
Check it again with the replacement face and finished graphic. A different acrylic grade, thickness or vinyl coverage can alter light distribution. Compare the full face and edges at the intended viewing distance.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
Are these featured bars suitable outdoors?
The featured 20W bar is IP20 for indoor use. Do not infer outdoor suitability from weather-resistant acrylic. Check each module, supply, enclosure and installation requirement for the actual environment.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with acrylic grade, thickness, graphic sample, lightbox dimensions and supply details before selecting sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Searching for BC Sign & Graphics Expo lightbox LEDs? Compare internal modules for your own indoor acrylic-face sign with the actual diffuser and printed or vinyl graphic.
Which LEDs suit an acrylic-face lightbox?
Test the actual acrylic grade, thickness and graphic with the proposed source layout. Face diffusion and transmission affect visible bright points and dark areas; a material name alone does not determine LED spacing.
Can I keep the same spacing after changing the face?
Check it again with the replacement face and finished graphic. A different acrylic grade, thickness or vinyl coverage can alter light distribution. Compare the full face and edges at the intended viewing distance.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
Are these featured bars suitable outdoors?
The featured 20W bar is IP20 for indoor use. Do not infer outdoor suitability from weather-resistant acrylic. Check each module, supply, enclosure and installation requirement for the actual environment.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with acrylic grade, thickness, graphic sample, lightbox dimensions and supply details before selecting sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.