Looking for AUSA Annual Meeting lightbox LED modules? A graphic supplier documents a front-centre lightbox image at this event. Compare independent sources for your own indoor printed booth display.
Will a lightbox that looks good head-on also look good from the side aisle?
A front-only view cannot establish that. Test the assembled graphic from the intended approach directions; record visible source patterns, dim image areas and frame-edge obstruction before choosing the layout.
Should I select the widest beam for my main booth image?
Beam angle alone does not establish the best result. Compare the intended edge-lit or rear-backlight arrangement with the actual print and frame depth; review the complete image from the planned aisle positions.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
Are these lights for defense equipment or outdoor exhibits?
This selection concerns indoor printed exhibition lightboxes. No defense-equipment, outdoor or proprietary-frame approval is claimed. Check the exact model for your own build.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send the graphic, frame section and front/side viewing positions through Contact us to compare sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Looking for AUSA Annual Meeting lightbox LED modules? A graphic supplier documents a front-centre lightbox image at this event. Compare independent sources for your own indoor printed booth display.
Will a lightbox that looks good head-on also look good from the side aisle?
A front-only view cannot establish that. Test the assembled graphic from the intended approach directions; record visible source patterns, dim image areas and frame-edge obstruction before choosing the layout.
Should I select the widest beam for my main booth image?
Beam angle alone does not establish the best result. Compare the intended edge-lit or rear-backlight arrangement with the actual print and frame depth; review the complete image from the planned aisle positions.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
Are these lights for defense equipment or outdoor exhibits?
This selection concerns indoor printed exhibition lightboxes. No defense-equipment, outdoor or proprietary-frame approval is claimed. Check the exact model for your own build.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Send the graphic, frame section and front/side viewing positions through Contact us to compare sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.