Looking for APTA EXPO lightbox LED modules? Compare internal sources for your own tall single-sided printed brand display used around a public-transportation exhibition.
Which LED layout suits a tall single-sided lightbox?
Compare edge-lit and rear-backlight arrangements with your frame depth and finished print. Check source direction and mounting space along the whole height, not just one end of the panel.
Is a small illuminated print sample enough?
Use it to compare material response, then test the full graphic in the intended frame. Check the top, middle and bottom from planned viewing positions; a small sample cannot establish full-height uniformity.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What should I send before ordering modules?
Send graphic height and width, frame section, usable depth, face material, source layout and supply details. Confirm the freestanding structure with your builder; these modules do not include event sponsorship, placement or installation services.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your full-height graphic and frame details to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.
Looking for APTA EXPO lightbox LED modules? Compare internal sources for your own tall single-sided printed brand display used around a public-transportation exhibition.
Which LED layout suits a tall single-sided lightbox?
Compare edge-lit and rear-backlight arrangements with your frame depth and finished print. Check source direction and mounting space along the whole height, not just one end of the panel.
Is a small illuminated print sample enough?
Use it to compare material response, then test the full graphic in the intended frame. Check the top, middle and bottom from planned viewing positions; a small sample cannot establish full-height uniformity.
Compare LED lightbox sources
- 20W rigid edge-lit bar: 470×24×16mm including lens, DC24V, 2200lm ±10% and 10°×40° optics.
- 12W dual-CCT rear-backlight bar: DC24V, 1320lm, 180° beam and 3-wire JST; select the CCT pair and separate control.
- 10W slim edge-lit bar: 360×23×16mm including lens, DC24V, 1100lm and 9°×50° optics.
What should I send before ordering modules?
Send graphic height and width, frame section, usable depth, face material, source layout and supply details. Confirm the freestanding structure with your builder; these modules do not include event sponsorship, placement or installation services.
Before ordering
For the three featured bars: Verify DC24V, total load, pinout and polarity; external power is separate. The dual-CCT bar also requires a compatible 3-wire switch or controller, not included. The featured slim 10W bar permits at most 6 per run after wiring checks; do not apply that limit to other models.
Browse all LED Modules below. Contact us with your full-height graphic and frame details to compare suitable internal sources.
Contact us · Shipping policy · Organizer information
BOOTH LIGHTS is an independent supplier; no affiliation with or endorsement by the event organizer is implied.